Positioning The Logs - Heat & Glo Escape-42DV Owner's Manual

E. Positioning the Logs
If the gas logs have been factory
installed they should not need to be
positioned. If the logs have been
packaged separately, refer to the
following instructions.
NOTE: If sooting occurs, the logs
may need to be repositioned slightly
to avoid excessive flame impinge-
ment.
CAUTION:
Logs are fragile!
Carefully remove the logs from
the packaging.
Step 1.
Note: If bulb and orange lens
are already installed, proceed to
Step 2.
Remove the bulb from its pack-
aging and locate the sockets in-
stalled in the square cut outs in
the firebox floor. The bulbs con-
tacts push into the two small
holes in the socket top, as
shown.
Place the framed orange lens on
top of the firebox floor covering
the bulb as shown. The four tabs
on the lens frame go into the
square cut out to help locate the
lens.
32
6
7
1 1
Figure 12.1
Figure 12.2
Figure 12.3
Heat & Glo • Escape-42DV • 2052-900 Rev. B • 5/05
Log Assembly: LOGS-Escape-42
3
4
8
5
2
1
2052-925