Eaton 9130 UPS User Manual page 30

INSTALLATION
22
Eaton ® 9130 UPS (700–3000 VA) User's Guide
NOTE There are two sets of four mounting holes on each side of the UPS: a forward
position and a middle position. Choose the position that meets your configuration needs.
Figure 6. Installing the Mounting Brackets (Forward Position Shown)
10. If installing optional cabinets, repeat Steps 8 and 9 for each cabinet.
11. Slide the UPS and any optional cabinets into the rack.
12. Secure the front of the UPS to the rack using two M6 16 pan-head
screws and two M6 cage nuts on each side (see Figure 7). Install
the bottom screw on each side through the bottom hole of the
mounting bracket and the bottom hole of the rail.
Repeat for any optional cabinets.
M6 Cage Nuts
(4 places)
Figure 7. Securing the Front of the Cabinet
S 164201718 Rev 3 www.eaton.com/powerquality
Mounting
Bracket
M4 8 Flat-Head
Screws (4 places)
M6 16 Pan-Head
Screws (4 places)