Table of Contents
Advertisement
STEP 7.
LOG #6 (SRV2077-701): Set log #6 onto the grate bar as shown. Lay the "Y" end of log #6 onto log #1 resting
it into the small depression of log #1.
3
5
2
7
F. Glass Assembly
WARNING
Handle glass doors with care.
• Inspect the gasket to ensure it is
undamaged.
• Inspect the glass for cracks, chips or
scratches.
• Do NOT strike, slam or scratch glass.
• Do NOT clean glass with a razor blade.
• Do NOT operate appliance with glass door removed,
cracked, broken or scratched.
• Replace glass door assembly as a complete appliance.
Removing Glass Assembly
Remove wing nuts and glass clips around glass door.
Remove glass door from the appliance.
Replacing Glass Assembly
Replace the glass door on the appliance.
1
4
6
Heat & Glo LifeStyle Collection • Twilight-II-B • 2108-900 Rev. E • 11/06
3
5
2
STEP 8.
LOG #7 (SRV703-703): Place log #7 on
the grate tine between log #2 and log #5. Rest one
end on the burner making sure not to cover any port
holes.
G. Grilles and Trim
Install optional marble and brass trim surround kits as de-
sired. Marble, brass, brick, tile, or other non-combustible
materials can be used to cover up the gap between the
sheet rock and the appliance.
Do not obstruct or modify the air inlet/outlet grilles. When
overlapping on both sides, leave enough space so that
the bottom grille can be lowered and the trim door re-
moved.
H. Shutter Settings
Twilight-II-B
1
4
6
NG
LP
3/8 in.
Full Open
29
Advertisement
Table of Contents
