Heat & Glo LifeStyle Twilight-II-B Owner's Manual page 14

Placing and Securing Appliance
Place the appliance into position. Make sure fl ashing edges
on the outdoor surround fi t up tight to the framing.
The diagram shows how to properly position, level, and
secure the appliance (see Figure 5.13). Nailing tabs are pro-
vided to secure the appliance to the framing members.
• Caulk behind fl anges before securing to framing.
• Place the appliance into position.
• Level the appliance from side to side and front to
back.
• Shim the appliance as necessary.
• Keep nailing tabs fl ush with the framing.
• Secure the appliance to the framing by using nails or
screws through the nailing tabs.
SECURE TO FRAMING
APPLIANCE
IN A MINIMUM 3
EXTERIOR
PLACES PER SIDE
NOTE: Caulk behind all fl anges before securing to the exterior.
Figure 5.13 Proper Positioning, Leveling and
Securing of a Appliance
CAUTION
Do NOT notch into the framing around the appliance
spacers.
14
SECURE TO
FRAMING
Heat & Glo LifeStyle Collection • Twilight-II-B • 2108-900 Rev. E • 11/06
Placing Flashing and Sheathing
Apply RTV sealant to corner edges of fi replace fl ange (see
Figure 5.14).
APPLY RTV
SEALANT TO
CORNER EDGES
FIREPLACE
FLANGE
BEND IN
FLANGE
Figure 5.14
Install outdoor fl ashing header (sheetmetal piece removed
from shipping pallet). Place over upper portion of shroud
fl ange. Line up holes on shroud sides (see Figure 5.15)
FLASHING
HEADER
(SLIDE DOWN)
FLASHING
HEADER
(INSTALLED)
Figure 5.15