Table of Contents
Advertisement
E. Junction Box Installation
If the box is being wired from the OUTSIDE of the
appliance:
• Install the
Romex™
connector (not included with
appliance) in the side wrap.
• Loosen two screws on the Romex connector, feed
the necessary length of wire through the connector
and tighten the screws.
• Make all necessary wire connections.
If the box is being wired from the INSIDE of the
appliance:
• Remove the screw attaching the junction box to
the outer shell, rotate the junction box inward to
disengage it from the outer shell (see Figure 7.4).
• Pull the electrical wires from outside the appliance
through this opening into the valve compartment.
F. Wall Switch Installation for Fan (Optional)
If the box is being wired to a wall
mounted switch for use with a fan
(See Figure 7.5):
• The power supply for the appliance
must be brought into a switch box.
• The power can then be supplied
from the switch box to the appli-
ance using a minimum of 14-3 with
ground wire.
• At the switch box connect the black
(hot) wire and red (switch leg) wire
to the wall switch as shown.
• At the appliance connect the black
(hot), white (neutral) and green
(ground) wires to the junction box
as shown.
• Add a 1/4 inch insulated female
connector to the red (switch leg)
wire, route it through the knockout
in the face of the junction box, and
connect to the top fan switch con-
nector (1/4 inch male) as shown.
22
• Loosen the two screws on the Romex connector, feed the
• Make all necessary wire connections to the receptacle and
FAN
SPEED CONTROL
(RHEOSTAT)
Figure 7.5 Junction Box Wired to Wall Switch
Heat & Glo LifeStyle Collection • Twilight-II-B • 2108-900 Rev. E • 11/06
HEAT SHIELD
WHT
BLK
BLK
WHT
Figure 7.4 Junction Box Detail
necessary length of wire through the connector and tighten the
screws.
assemble the receptacle and cover to the junction box.
6 INCH
APPROX.
FAN
PLUG AND WIRE
ASSEMBLY
14/2WG
COPPER GROUND
ATTACHED TO GRN SCREW
WITH GRN WIRE
GREEN WIRE
INSIDE BOX
NOTE: Do NOT wire
110 VAC to wall switch.
WIRE LEAD
1 MALE END
1 FEMALE END
TEMPERATURE
SENSOR SWITCH
WIRE LEAD
2 FEMALE ENDS
JUNCTION
6 INCH
APPROX.
OPTIONAL
WALL SWITCH
BOX
Advertisement
Table of Contents
