Table of Contents
Advertisement
11
Appliance Setup
A. Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Glass installation and
removal should be performed only by a qualified service
technician. Handle fixed glass assembly with care. In-
spect the gasket to ensure it is undamaged and inspect
the glass for cracks, chips or scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fireplace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Installing Fixed Glass Assembly
1. Identify the top and bottom of the glass assembly. The
top of the glass frame has three engagement grooves.
The engagement groove is highlighted in Figure 11.1.
Figure 11.1 Glass Top Tab Detail.
2. Start by tipping the top of the glass frame toward the
fireplace. Center the glass between the left and right
firebox supports. Push "up" and "in" and set the glass
assembly on the bottom three glass latch tabs. See
Figure 11.2 .
Figure 11.2 Initial Positioning of Frame into Opening.
Heat & Glo • ESC-42ST-IFT Installation Manual • 2464-980 Rev. C • 7/17
3. With the glass assembly resting (not engaged) on the
bottom glass latch tabs, allow for the top of the glass
assembly to tip away from the fireplace. Lift up slightly
and ensure the glass assembly bottom seal is tight to
the bottom of the firebox. See Figure 11.3.
Figure 11.3 Second Position of Frame into Opening.
4. Engage the bottom glass latch tabs into the three slots
in the bottom of the glass frame.
To engage the tabs into the frame slots, manipulate the
glass clips by pulling out the glass latch handles. Figure
11.3 shows the middle glass latch tab engaged.
Engage an end latch first, then middle latch, and finally
the last end latches.
Figure 11.4 Glass Latch Engaged into Frame Latch.
TAB
HANDLE
39
Advertisement
Table of Contents
