Table of Contents
Advertisement
E. Positioning the Logs
Log Set Assembly: LOGS-TWI
3
5
2
7
CAUTION:
Logs are fragile! Carefully remove the logs
from the packaging. Remove the metal supports which
held the log box in place during shipping.
Indents
STEP 2.
LOG #1 (SRV2005-701): Use the indents on the bottom side of the log to position the large end of the log onto
the grate tine as shown. Position the thin end of log #1 one inch from port pattern as shown.
Grate Bar Cutout
STEP 3.
LOG #2 (SRV2005-700): Position log #2 on the left grate bar and the pilot assembly. Use the cut out notches
on the log to position it as shown.
1
4
6
Pilot
Assembly
Cutout
Heat & Glo LifeStyle Collection • Twilight-II-B • 2108-900 Rev. E • 11/06
STEP 1.
Before positioning the logs, refer to the instal-
lation manual for electric ember setup and ember place-
ment.
1-inch
2
1
1
27
Advertisement
Table of Contents
