Heat & Glo LifeStyle Twilight-II-B Owner's Manual page 13

Indoor/outdoor gas fireplace

Hide thumbs Also See for Twilight-II-B:

Table of Contents

Enlarged version

Figure 5.9

Step 8. Place new colored shroud over existing left and

right ﬁ replace sides and ﬁ replace top.

Figure 5.10

Step 9. Replace three screws on both the left and right

sides of ﬁ replace, and three screws on the top of ﬁ re-

place.

Figure 5.11

Step 10. Install lower splash guard between left and right

lower column. Push toward back wall.

Step 11. Attach splash guard across the front with three

screws provided (see Figure 5.12).

Heat & Glo LifeStyle Collection • Twilight-II-B • 2108-900 Rev. E • 11/06

Figure 5.12

Step 12. Attach left side of splash guard with 2 screws provi-

ded and repeat on right side of splash guard (see Fig. 5.3).

Step 13. Place new colored exterior cover plate between

lower left and right shroud sides and hook onto shoulder

bolts in shroud sides. (See Figure 5.2).

Installing Hood (REQUIRED before Operation).

Step 14. Attach new colored hood with two hood clips on

shroud. (See Figure 5.6).

Step 15. Fasten hood in place with 3 bit-tip screws. (See

Figure 5.5).

Figure 5.13

Step 16. Place new colored wind diffuser between up-

per left and right side of ﬁ replace columns and attach to

shoulder bolts at right and left of ﬁ replace.

Step 17. Attach wind diffuser with screw on right and left

side of ﬁ replace. (See Figure 5.4).

Table of Contents