Heat & Glo LifeStyle Twilight-II-B Owner's Manual page 12

Figure 5.3
Step 2. Remove splash guard by removing two screws on
both the right and left sides, and three screws from across
the splash guard front.
Figure 5.4
Step 3. Remove wind diffuser by removing one screw
from both the right and left sides (see Figure 5.4). Unhook
the wind diffuser from the shoulder bolts on the right and
left side of the appliance.
Fasten hood with tip
screws.
Figure 5.5
Step 4. Remove three screws from underside of hood.
12 Heat & Glo LifeStyle Collection • Twilight-II-B • 2108-900 Rev. E • 11/06
Figure 5.6
Step 5. Remove the black hood from the two hood clips
on the shroud.
Replacing Shroud
Figure 5.7
Step 6. Release glass spring clips located on the lower left
and right of exterior of fi replace and remove the glass.
Figure 5.8
Step 7. Remove three screws from both the left and right
sides of fi replace, and three screws from the top of fi re-
place. Remove black shroud.