HearthStone Stowe 8320 Owner's Manual & Installation Manual page 23

HearthStone Quality Home Heating Products Inc
thermostat, being sure to leave a small coil
of wire behind the unit so that it can be
moved out of position for servicing and
cleaning. (At the thermostat, the wires
should be connected to the two connection
screws on the back of the thermostat per the
instructions received with the thermostat)
Take care not to over-tighten the connection
screws and not to damage the internal parts
of the thermostat.
B F
LOWER AN
The unit can also be equipped with an
optional variable speed blower fan, Kit #93-
57200, which turns on and off independently
of the burner flames. Installation instructions
are provided with the Kit.
E
LECTRICAL GROUNDING
I W
NSTRUCTIONS
F I I
AN S NSTALLED
This appliance is equipped with a three-
prong (grounding) plug for your protection
against shock hazard and should be plugged
directly into a properly grounded three-
prong receptacle. Do not cut or remove the
grounding prong from this plug.
W I
IRING NSTRUCTIONS
CAUTION:
¦ Label all wires prior to
disconnection when servicing controls.
Wiring errors can cause improper and
dangerous operation.
operation after servicing. (Attention: Au
moment de l'entretien des commandes,
étiquetez tous
débranchement. Des erreurs de câblage
peuvent entraîun
inadequate et dangereux.)
The proper location of wire connections is
shown in Figure 7.
B
HEN LOWER
Verify proper
les fils avant le
fonctionnement
STOWE Gas-Fired Direct Vent heater
23