Touchpad - HP EliteBook 9470m Maintenance And Service Manual

5. Lift the base enclosure (1) off the computer while threading the antenna cables through the hole in
the base enclosure (2).
Reverse this procedure to install the base enclosure.

Touchpad

Before removing the touchpad, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
a.
Hard drive cover (see
b.
Hard drive (see
c.
Service cover (see
d.
Keyboard (see
e. Base enclosure (see
Remove the touchpad:
1. Remove the 2 Phillips PM2.0×3.0 screws (1) that secure the touchpad to the computer.
Battery on page 41), and then remove the following components:
Hard drive cover on page
Hard drive/SSD drive on page
Service cover on page
Keyboard on page 60)
Base enclosure on page
47)
48)
53)
63)
Component replacement procedures
65