Arming The System; Full Arming Mode; Perimeter Arming Mode - Videofied VIA-Pro Owner's Manual

Arming the System

You can arm your system whether you
are leaving or staying on the premises.
Choose from the following procedures.

Full Arming Mode

Arming to this mode provides
protection for all perimeter and
interior areas. Use this procedure
when leaving the premises.
1. Close all protected doors
and windows.
.
2 Gather any belongings you want
to take with you.
3. Arm the system:
At the Keypad nearest an entry/exit
delay door, enter:
Access Code
If arming from a Keyfob,
press the ON button.
The Keypad responds by displaying
ARMING THE SYSTEM, the LED flashes
once every two seconds, and a beep
sounds every second indicating the exit
delay has started and the system is
arming.
4.
Immediately leave through the
entry/exit delay door.
Note:
If any detection sensors are activated
during the exit delay, the system momen-
tarily stops the arming sequence.
The Keypad display shows DETECTION,
identifies the activated sensor(s), then
changes to ESC = REJECT EQUIP, YES = TRY
AGAIN.
If you choose to try again, you must first
close the identified sensor(s) before pressing
YES.
V i d e o f i e d S e c u r i t y Sy s te m O w n e r s M a n u a l
+
YES
If you choose to reject(bypass), this means
the identified sensor(s) will not trigger an
alarm during this arming period.
If you do not make a choice after three
minutes, the system automatically bypasses
the identified sensor(s) for this arming
period and arms the rest of the system.

Perimeter Arming Mode

Arming to this mode provides
protection for the perimeter (doors
and windows) only. This allows persons
to stay inside the premises and move
freely without triggering motion
detectors. You can use this mode
whether you are leaving or staying
on the premises. This mode works
well for overnight sleeping periods.
1. Close all protected doors
and windows.
2. Arm the system:
At the Keypad nearest an entry/exit
delay door, enter:
Access Code
+
The Keypad responds by displaying
ARMING THE SYSTEM, the LED flashes
once every two seconds, and a beep-
sounds every second indicating the
exit delay has started and the system
is arming.
3. If leaving, do so immediately through
an entry/exit delay door.
If staying, notice the Keypad LED
flashes once every two seconds and the
display shows SYSTEM ARMED.
Caution!
To avoid an accidental alarm
when arming to this mode and staying inside,
remember to disarm the system before
opening any doors and/or windows.
Note: Keyfobs do not have perimeter arming
modes
+
YES
7