New Construction Installation - Bg radia BGX Owner's Manual And Setup Procedures

New construction installation

1. During pre-wire, pull wire to the planned subwoofer
locations. You will need (one) two-conductor wire per
woofer module (or one four-conductor wire per pair
of modules).
2. Remove the new construction bracket (NCB) from the
packaging and install it in the stud bay in the desired
location. Make sure that its side metal flanges are set
tightly against drywall surface. Using at least four long
wood screws and a screw gun, install NCB as shown on
Fig. 4 Installing NCB and subwoofer module for new construction
775-884-1900
New Construction Installation
>
3535 Arrowhead Drive
ph · 775-884-1276 fx ·
Fig. 4 on the left. Level the NCB if necessary using the
bend out metal tabs to account for any tolerance.
3. Take the subwoofer module with protective cover
attached and install it inside NCB using the four
supplied machine screws in the same way as shown in
Fig. 3. Make sure it is fastened tightly and does not
rattle. Refer to the right image on Fig. 4.
· Carson City, NV 89706
www.bgradia.com · sales@bgradia.com
9