Assembly Instructions - Diamondback 400Tm Owner's Manual

Please take the assembly hardware out of the hardware package box. Lay all the
hardware out and take note for its locations. Follow the assembly instruction step
by step to complete the assembly.
Step 1: Upright Posts Assembly
1. Straight out the main wire harness and insert it though the top of left upright
post.
2. Slide the upright post onto its receptor and insert three M8 x55mm screws on
the side and two M8 x 15mm screws on the front. Tighten these 5 screws
with Allen wrench. Be careful not to pinch the main wire harness while
tightening these screws.
3. Repeat procedure 2 for the Right upright post.
4. Make sure the screws are securely tightened.
Step 2: Console Assembly
1. Hold the console next to the Left upright post and connect the main wire
harness connectors together.
2. Insert the console U bracket into each side of upright post. Be careful not to
pinch the wire harness while inserting the U bracket.
3. Insert three M8 x12mm screws each on inner and outer Left upright post
(totally 6 screws on each upright post).
4. Tighten the 6 screws securely with Allen wrench.
5. Repeat procedure 3 & 4 for Right upright post.
6. Make sure all screws are securely tightened.
400 Tm Owner's Manual

Assembly Instructions

7