Fireplace Framing And Installation - Empire Comfort Systems OLP36FP72SN-2 Owner's Manual

FIREpLACE FRAMING AND INSTALLATION

Locate the three metal framing studs:
OLP36FP Two - 42" Stud
OLP42FP Two - 42" Stud
1. Secure the metal studs to the frame using six #10 pan-head
screws as shown in Figure 8. The channel of the studs
should face as shown in Figure 8.
f
2. Install flanges on side of fireplace as shown using holes on
side of fireplace. See Figure 9. The middle pair of holes if for
the 1/2 inch non-combustible board provided with the unit.
Page 12
SIDE TOP
One - 41-5/8" Top Stud
One - 45-5/8" Top Stud
Figure 8
Figure 9
3. Locate the middle bracket. Loosen the screw in the middle
top of the fireplace. Slide the bracket under the screw as
shown in Figure 11. Tighten the hex-head screws on the
fireplace secure a pan-head screw through the middle
bracket and into the top stud.
4. Slide the fireplace into position inside the metal studs.
Secure the fireplace to the metal studs with four #10 pan-
head screws as shown in Figure 10.
Note: Ensure that the gas shut-off valve is accessible.
5. Connect the gas line to the unit and check for leaks with a
soapy water solution.
Note: Ensure that the gas shut-off valve is accessible.
6. Locate the two non-combustible boards and place them
above the fireplace as shown in Figure 12. Attach the
non-combustible board to the studs with six 10-16 flathead
screws.
7. Secure the non-combustible board to the middle bracket
using two 10-16 flathead screws as shown in Figure 12.
Figure 10
Figure 11
32274-0-0713