Table of Contents
Advertisement
1. Before beginning, remove door and log package from
unit. Also check to make sure there is no hidden dam-
age to the unit. Take a minute and plan out the gas and
followed by the electrical supply requirements.
Figure 2
fractory), glass doors, screen rails, screen mesh and
log grates can be removed from a
in order to gain minimum gas insert opening require-
3. This insert requires no hearth extensions. Combustible
Do not obstruct the lower louver of the insert. The origi-
dition.
to facilitate the installation of the insert. The side walls
place cannot be returned to solid fuel in this condition.
5. The insert surround is tested and approved with this
gas insert and may cover existing air circulation vents
the surround does not cover the entire ventilation grill
surface, the exposed grill area should be left open.
Page 8
INSTALLATION IN A FIREPLACE
-
See "Positioning, Leveling and Securing Insert" below.
6. Install the insert without the surround panels attached
and make all gas venting and electrical connections.
-
cess holes provided, an access hole of 1 1/2" di-
-
place has been installed with all the gas and electrical
tions included with the surround panel kit.
-
Positioning, Leveling and Securing Insert
1. Place the insert into position
Note:
panels) should be set at approximately 1" in front of
2. Level the insert from side to side and front to back.
3. If necessary, use the leveling bolts included in the instruc-
tion pack. Screw the legs into the nuts installed in the bottom
of the insert. Turn legs in until insert is level.
NOTE: The best way to access the leveling bolt loca-
-
-
-
-
-
-
26497-6-0511
Advertisement
Table of Contents
