Table of Contents
Advertisement
danGer
!
Installer:
leave this manual with the
appliance.
consumer: retain this manual for future
reference.
— Do not store or use gasoline or other flam-
mable vapors and liquids in the vicinity of
this or any other appliance.
— Installation and service must be performed
by a qualified installer, service agency or the
gas supplier.
warnInG
If the information in these instructions are not
followed exactly, a fire or explosion may result
causing property damage, personal injury or
loss of life.
warnInG
Improper installation, adjustment, alteration, ser-
vice or maintenance can cause injury or property
damage. read the installation, operating and main-
tenance instructions thoroughly before installing
or servicing this equipment.
InstallatIon InstructIons
and owner's Manual
GAS-FIRED
this appliance can produce carbon monoxide which has
no odor.
using it in an enclosed space can kill you.
never use this appliance in an enclosed space such as a
camper, tent, car or home.
outdoor Ventless
decoratIVe aPPlIance
MIllIVolt Models
onr-24-2
onr-30-2
InterMIttent Models
onI-24-2
onI-30-2
carBon MonoXIde HaZard
warnInG
For outdoor use only.
warnInG
If not installed, operated and maintained in
accordance with the manufacturer's instructions,
this product could expose you to substances in
fuel or from fuel combustion which can cause
death or serious illness.
warnInG
If you smell gas:
1. shut off gas to the appliance.
2. Extinguish any open flame.
3. If odor continues, keep away from the appliance
and immediately call your gas supplier or fire
department.
warnInG
Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
an lP-cylinder not connected for use shall not be
stored in the vicinity of this or any other appliance.
Page 1
Advertisement
Table of Contents
Related Manuals for Empire Comfort Systems ONR-24-2
Summary of Contents for Empire Comfort Systems ONR-24-2
- Page 1 InstallatIon InstructIons and owner's Manual outdoor Ventless decoratIVe aPPlIance MIllIVolt Models onr-24-2 onr-30-2 GAS-FIRED InterMIttent Models onI-24-2 onI-30-2 danGer carBon MonoXIde HaZard this appliance can produce carbon monoxide which has no odor. using it in an enclosed space can kill you.
-
Page 2: Table Of Contents
taBle oF contents section Page Important Safety Information ....................... 3 Safety Information for Users of LP Gas ..................4 Introduction ..........................5-7 Clearances ........................... 7 General Information ........................7-8 Specifications ..........................8 Before Fully Installing the Appliance .................... 8 Gas Supply ..........................9 Operation Instrudtions/Flame Appearance ................ -
Page 3: Important Safety Information
IMPoRTAnT SAFETY InFoRMATIon Installer: Please leave these instructions with the owner for future Proper installation, burner pan location and log placement is reference. important to achieve optimum look and performance of your gas log set. The logs have been designed for easy location and place- This unit complies with ANSI Z21.97/CSA 2.41 Decorative Gas ment on the grate and must be followed for proper operation. -
Page 4: Safety Information For Users Of Lp Gas
SAFETY InFoRMATIon FoR USERS oF LP-GAS Propane (LP-Gas) is a flammable gas which can cause The odorant in escaped gas can adsorb or absorb onto or fires and explosions. In its natural state, propane is odor- into walls, masonry and other materials and fabrics in a room. less and colorless. -
Page 5: Introduction
When installed on surfaces where water may collect or cause Always consult your local Building Department regarding regulations, damage: Empire Comfort Systems recommends a slope of 1/8 in codes or ordinances which apply to the installation of an unvented to 1/4 in per foot towards the drain port suggested. The fireplace room heater. - Page 6 IntroductIon Qualified Installing Agency • For appliances for fixed fuel piping system and equipped Installation and replacement of gas piping, gas utilization equipment with an appliance gas pressure regulator, the appliance and or accessories and repair and servicing of equipment shall be its individual shutoff valve must be disconnected from the performed only by a qualified agency.
-
Page 7: Clearances
IntroductIon Ventilation opening(s) shall be provided at floor • Cylinder valves shall be readily accessible for hand opera- level and shall have a total free area of not less tion. A door on the enclosure to gain access to the cylinder than 1/2 square inch per pound (3.2 sq. -
Page 8: Specifications
General InForMatIon (continued) Qualified Installing Agency High altitude Installation Installation and replacement of gas piping, gas utilization equipment When installing this unit at an elevation above 2000 feet (in the or accessories and repair and servicing of equipment shall be per- United States) it may be necessary to decrease the input rating by formed only by a qualified agency. -
Page 9: Gas Supply
GAS SUPPLY Check all local codes for requirements, especially for the size and type of gas supply line required. recommended Gas Pipe diameter Pipe Length Schedule 40 Pipe Tubing, Type L Inside Diameter Outside Diameter Nat. L.P. Nat. L.P. 0-10 feet 1/2”... -
Page 10: Operation Instrudtions/Flame Appearance
oPeratIon InstructIons/FlaMe aPPearance Flames from the pilot (rear right back side of the pan burner) as well as the main flame should be visually checked as the log set is installed. In normal operation at full rate after 10 to 15 minutes, the flame appearance should be sets of yellow flames. -
Page 11: Oni-(24,30) Lighting Instructions
onI-(24, 30) lIGHtInG InstructIons FOR YOUR SAFETY READ BEFORE LIGHTING WARnInG: IF YoU Do noT FoLLoW ThESE InSTRUCTIonS EXACTLY, A FIRE oR EXPLoSIon MAY RESULT CAUSInG PRoPERTY DAMAGE, PERSonAL InJURY, oR loss oF lIFe. a. this appliance has a pilot which must be lighted by c. -
Page 12: Oni-(24,30) Wiring
onI-(24,30) wIrInG shield Installation SECURE SHIELD TO VALVE WITH TWO SCREWS 1. Slip the split grommets over the wire harness. 2. Place the shield into position over the control module. 3. Feed wiring into slots on either side of the control shield. -
Page 13: Onr-(24,30) Lighting Instructions
onr-(24, 30) lIGHtInG InstructIons FoR YoUR SAFETY READ BEFoRE LIGhTInG warnInG: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. a. this appliance has a pilot which must be lighted by c. -
Page 14: Pilot And Main Burner Flame Characteristics
PIlot and MaIn Burner FlaMe cHaracterIstIcs Pilot Flame Pattern (Figure 4) Main Burner Flame Pattern Figure 4 shows a correct pilot flame pattern. The correct flame will The main burner flame will be completely yellow. be blue and will extend beyond the thermopile. The flame will sur- Main Burner Flame Ignition and extinction round the thermopile just below the tip. -
Page 15: Onr-(24,30) Wiring
onr(42,30) wIrInG wiring diagram Thermostats are not approved on vented decorated appliances. Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing. ONR gas valve does not require 24 or 110 volts. See Figure 5 to provide optional wall switch or remote control. -
Page 16: Remote Control Installation And Operation
reMote control InstallatIon & oPeratIon TWo-FUnCTIon WIRELESS REMoTE ConTRoL SYSTEM For on/oFF-HI/lo oPeratIon oF tHe aF-4000 Gas control ValVe IF YoU CAnnoT READ oR UnDERSTAnD ThESE InSTALLATIon InSTRUCTIonS Do noT atteMPt to oPerate IntroductIon This remote control system was developed to provide a safe, reliable, and user-friendly remote control system for use with the AF-4000 gas control valve used with some gas heating appliances. -
Page 17: Troubleshooting
trouBlesHootInG SYMPToMS-PoSSIBLE CAUSES AnD CoRRECTIonS 1. Match will not light pilot. 3. Pilot burning, no gas to burner, valve knob "on," wall switch a. Main shut-off valve closed. "on." • Make sure that the shut-off valve located on the pipe a. -
Page 18: Parts View & List
Parts VIews & lIst onI Models onr Models 9 10 9 10 13 12 13 12 TEMP TEMP Part no. description Index onI24 onI30 onr24 onr30 27934 27935 27934 27935 Rear Log Support 27930 27930 27930 27930 Burner Support Welded Assembly - Left 27936 27937 27936... -
Page 19: Master Parts Distributor List
This list changes from time to time. For the current list, please click on the Master Parts button at www.empirecomfort.com. Please note: Master Parts Distributors are independent businesses that stock the most commonly ordered Original Equipment repair parts for Heaters, Grills, and Fireplaces manufactured by Empire Comfort Systems Inc. dey distributing Victor division of F. -
Page 20: Warranty Terms
WARRAnTY TERMS Empire Comfort Systems Inc. warranties this hearth product to be free from defects at the time of purchase and for the periods specified below. Hearth products must be installed by a qualified technician and must be maintained and operated safely, in accordance with the instructions in the owner’s manual.
Need help?
Do you have a question about the ONR-24-2 and is the answer not in the manual?
Questions and answers
I purchased and placed per Order Receipt #3596448, it was though not until March 27, 2024 all the parts arrived (not broken) I was able to have a Licensed Plumber install and it worked great, but not clear why (I tried again last night – no wind) it only turned on for exactly 35 seconds and turned off. I can immediately restart it but again when I time it, it turns off 35 seconds. Because the file is so large I probably need to send you a dropbox link, but really all your going to see is the flame on for 35 seconds and then off.
A possible reason for the Empire Comfort Systems ONR-24-2 turning off after 35 seconds of operation could be a dirty or blocked burner air intake hole. If the air intake hole is not clean, it can cause sooting and improper combustion, leading to the appliance shutting off. Regular inspection and cleaning of the burner air intake hole with a brush are necessary to ensure proper operation.
This answer is automatically generated