Flytec 6020 Operating Manual page 26

EXIT Cylinder
The signal „waypoint reached" is audible as soon as the start time is reached and the
pilot is inside the start cylinder. It will also sound if the start time is positive and the pilot
crosses the start cylinder circumference from outside to inside. In both cases the next active
waypoint will be enabled, in this case Waypoint2. All calculations and the direction arrows
are now pointing to Waypoint2
If the pilot decides to take the next start gate, he must press the Prev WP ▼ key.
(Select with key the Sub-Menu Prev/Next WP). The instrument then enables WP1 again
McC
and will increment the start time by the preset difference. When the last start gate is reached,
the start time will no longer be increased after pressing of Prev. WP ▼.
Caution: for EXIT cylinder it is required that the first waypoint after the start cylinder is
outside of the start cylinder!
ENTER Cylinder
WP2
The signal „waypoint reached" is audible as soon as the start time is positive and the
pilot is crossing the start cylinder circumference from outside to inside. In this case the
next active waypoint will be enabled, in this case WP2. All calculations and the direction
arrows are now pointing to WP2
If the pilot decides to take the next start gate, he may press the Prev WP ▼ key.
(Select with key the Sub-Menu Prev/Next WP). He can do this regardless if he is present
McC
inside or outside of the cylinder. The instrument then enables WP1 again and will increment
the start time by the preset difference. When the last start gate is reached, the start time will
no longer be increased after pressing of Prev. WP ▼.
Caution: for ENTER cylinder it is required that the first waypoint after the start cylinder is
inside and usually in the centre of the start cylinder!
Operating Manual Flytec 6020
WP2
WP1
Exit
WP1
ENTER
- 26 -
WP3
WP3