Paper Misfeed In The Finisher Mj-1101 And The Hole Punch Unit Mj-6103 (Both Optional) - Toshiba e-studio 2040c Troubleshooting Manual

1.TROUBLESHOOTING FOR THE HARDWARE
If the misfed paper cannot be removed because the right side is
caught by the fuser unit, follow the steps on
in the fuser unit".
3
Close the cover of the Bridge Unit.
Paper misfeed in the Finisher MJ-1101 and the Hole Punch Unit MJ-6103 (both
optional)
Paper misfeed in the upper receiving tray
1
Raise the lever and open the upper receiving tray of
the finisher.
2
Remove the misfed paper.
3
Open the cover holding the handle of the Bridge Unit.
When the Hole Punch Unit MJ-6103 is installed, proceed to step 5.
1 TROUBLESHOOTING FOR THE HARDWARE
P.22 "Paper misfeed
Clearing a Paper Misfeed 25