Refilling Saddle Stitch Unit Staples (Mj-1106) - Toshiba e-studio 2040c Troubleshooting Manual

1 TROUBLESHOOTING FOR THE HARDWARE
8
Fit the staple cartridge into the stapler.
Insert the staple cartridge until it is caught by the latch of the staple
cartridge and is fixed with a click.
9
Close the staple cartridge unit cover.
10
Connect the finisher to the equipment.
Move the finisher slowly toward the equipment, placing both of your
hands on the front and the back of the finisher.
If the message "Check staple cartridge" remains, repeat the procedure above from steps 1 to 10.

Refilling Saddle Stitch unit staples (MJ-1106)

When the staples of the stapler in the Saddle Stitch Finisher MJ-1106 have run out, refill the staples following the
procedure below.
1
Open the front cover of the finisher, and pull out the
Saddle Stitch unit until it stops.
60 Refilling With Staples