Paper Misfeed In The Finisher, Hole Punch Unit And Inserter (All Optional) - Toshiba e-studio556 Troubleshooting Manual

1 TROUBLESHOOTING FOR THE HARDWARE
Check that there is no folded/curled paper or
5
overloading, and then close the drawer of the Large
Capacity Feeder.
Be sure that the height of the stacked paper does not exceed the
line indicated in the guide plate on the rear side.
Connect the External Large Capacity Feeder to the
6
equipment.
Slowly move the External Large Capacity Feeder placing your hands
on the positions shown in the figure.
 Paper misfeed in the Finisher, Hole Punch Unit and Inserter (all optional)
Separate the finisher from the equipment while
1
pushing the lock lever.
Place your hand on portion A in the figure and then move the finisher
carefully.
When the Hole Punch Unit is installed, open the Hole
2
Punch Unit cover.
Turn the green dial until the triangle mark (
3
within the designated area of the label.
20 Clearing a Paper Misfeed
A
) falls