Toshiba e-studio 2040c Troubleshooting Manual page 37

1.TROUBLESHOOTING FOR THE HARDWARE
5
Open the cover of the Hole Punch Unit when it is
installed.
6
Turn the knob shown in the following figures to send the paper, and then remove the
misfed paper.
When the Hole Punch Unit is installed, open the front cover of the finisher and turn the 2 knobs at the same
time.
When the Hole Punch Unit is not installed
Some misfed paper may get inside of the Saddle Stitch unit depending on the location where the misfeeding
occurs. In this case, follow step 7.
7
Turn the green knob to lower the paper until it is
hidden.
8
Holding the green knob, return the guide to the left.
1 TROUBLESHOOTING FOR THE HARDWARE
When the Hole Punch Unit is installed
Clearing a Paper Misfeed 35