Lexmark E260 Service Manual page 69

Paper jam error codes (200-series) (Continued)
Error
242.01 Took too long to ramp up dc feed motor
242.08 Received lots of dc feed interrupts before losing them
242.10 Second pick attempt failed from Tray 2
242.12 Second pick from manual feeder, tray 1, or feeder
failed when media was in the source, other sheets
were committed to the paper path.
242.16 Failed to feed from tray 2. Pages in the paper path
have been flushed to the output bin.
251.00 Paper jam near the manual feeder.
251.10 Second pick attempt failed from manual feeder.
251.11 Failed to feed from manual feeder. Pages in the paper
path have been flushed to the output bin.
251.12 Second pick from manual feeder, tray 1, or feeder
failed when media was in the source while the other
sheets were committed to the paper path.
251.19 Media never reached the input sensor from the manual
feeder.
251.20 The media in the MPF has been pushed in too far.
251.21 The media in the MPF has been pushed in too far.
Description Action
Check the connection with Tray 2. (Lift the printer
and re-set it on Tray 2.) If the error persists, then
replace Tray 2.
Remove Tray 2 and inspect for obstruction in the
paper path. Check the pick tires for wear or paper
dust. Replace if necessary. Check the wear strips
and replace if necessary.
Check the wear strips and replace them if worn.
Remove Tray 2 and inspect for obstruction in the
paper path. Check the pick tires for wear or paper
dust. Replace if necessary. Check the wear strips
and replace if necessary.
Inspect the pick roller on the MPF or the rollers on
the manual feed. If the MPF pick roller is damaged or
worn, then replace the MPF. For a printer with a
manual feed only (no MPF), clean the roller.
Remove the media, realign the stock, and re-insert.
Do not let the top sheets to go beyond the wear
strips.
Diagnostics information
4513-200, -220, -230
2-41