HP Compaq Elite 8300 All-in-One Maintenance & Service Manual page 121

System does not power on and the LEDs on the front of the computer are not flashing.
Cause
System unable to power on.
Solution
Press and hold the power button for less than 4 seconds. If
the hard drive LED turns green, then:
1. Check that the voltage selector, located on the rear of
the power supply on some models, is set to the
appropriate voltage. Proper voltage setting depends on
your region.
2. Replace the system board.
OR
Press and hold the power button for less than 4 seconds. If
the hard drive LED does not turn on green then:
1. Check that the unit is plugged into a working AC outlet.
2. Open computer and check that the power button board
cable is properly connected to the system board.
3. Check that power supply cables are properly connected
to the system board.
4. Check to see if the 5V_aux light on the system board is
turned on. If it is turned on, then replace the power
button board.
5. If the 5V_aux light on the system board is off, then
replace the power supply.
6. Replace the system board.
Solving general problems 113