Area Code Into Memory - Regency 500 Series User Manual

User's Guide
Programming The Telephone
Ringer Volume and Ring Tone Selection
There are two versions of the Regency 500:
1 Version One:
- The switch used to adjust the ringer
volume is located on the right side of
the telephone base. To adjust the
loudness of the ringing, slide the switch
to the desired position of HI/LOW/OFF.
The factory sets the ringer volume to
the HI position.
- One ring tone available.
2 Version Two:
The Ringer Volume and 4 selections of
ring tones are accessed through the
Directory Store Key
- With the handset on-hook, press
the DIRECTORY/STORE key until the
LCD display reads VOLUME <<<
( Figure 1). The ringer volume is
initially set to the 4th level of the
volume range. Use the VOLUME key,
located below the dial pad, to
adjust the volume. The ringer
volume control will automatically set to the selected level for
the next phone call.
- Press the DIRECTORY/STORE key again. The LCD display will
read RINGER TONE 0 — 3: 0 ( Figure 2). Then enter the digit
number ( 0, 1, 2, 3) of the desired ringer tone. The ringer tone
control will automatically set to selected level for the next
phone call.
Regency™ Series 500 Single Line Caller ID Telephone
24
Figure 1
Figure 2
User's Guide
Programming The Telephone

Area Code into Memory

If your local telephone company does not deliver the area code
with a local number's caller ID information, it is not necessary to
program this feature.
The area code is programmed into memory to allow the
telephone to recognize the local
area code. When this number is
programmed, the area code will
not be dialed when using the call
back feature to call back a
person within the same local
calling area.
Note: Programming should be performed with the telephone on-
hook
1 Press the DIRECTORY / STORE key (located on the top side of
the base) until ENTER AREA CODE is displayed on the LCD
screen.
2 Enter the area code number of your location using the
numeric dial pad. Do not enter a '1' as the first digit.
3 Press the DIRECTORY / STORE key again and the screen will go
back to its normal position after a 15 second delay.
Regency™ Series 500 Single Line Caller ID Telephone
13