Activate Your Wireless Account; Insert The Sim Card Into Holder, If Required - Multitech MultiModem rCell MTCBA-X-EN2 Quick Start Manual

MultiModem rCell Intelligent Wireless Router

Activate your Wireless Account

Please refer to the wireless account Activation Notice included with
your product and located on the MultiModem CD. Follow the directions
on the Activation Notice to activate your account.
Note: If you need remote access to your MultiModem over the
Internet for remote configuration, you need to ensure that your
wireless network provider has provisioned mobile terminated data
and fixed or dynamic public IP address in which they can configure
the network to redirect any incoming connection to that predefined
IP.

Insert the SIM Card into Holder, If required

The MultiModem requires the power supply connection to begin
operation. It also requires a SIM card (Subscriber Identity Module) to
operate on a GSM network. To install the SIM, do the following:
1. Using a small Phillips screwdriver, remove the two SIM door
screws and remove the SIM door.
Note: When changing a SIM, ensure that power is removed from
the unit.
2. Insert the SIM card into the card holder. The above graphic
illustrates the correct SIM card orientation.
3. Verify that the SIM card fits into the holder properly and then
replace the cover.
Multi-Tech Systems, Inc. Quick Start Guide 5