Multitech MultiModem rCell MTCBA-X-EN2 Quick Start Manual page 13

MultiModem rCell Intelligent Wireless Router
The Setup Wizard Screen
The following is a screen shot of the Setup Wizard. Using this screen
saves you time so that you are not entering the same information
several screens; the data entered here defaults to the other screens.
IP Configuration
IP Address – The default is 192.168.2.1. To change it, simply
enter your own IP address.
Mask – The default is 255.255.255.0
DNS – Enter the primary DNS IP address for the system. The
default is 0.0.0.0
PPP Configuration
PPP – The default is Disable. To connect to the Internet, you
have to enable PPP.To issue commands to the modem, PPP
must be disabled and telnet port 5000 used.
Dial-on-Demand – The default is Disabled.
Idle Time Out – Sets the amount of time the PPP link stays
active before disconnecting. Setting the value to zero causes the
link to stay active continuously.
Dial Number – Enter the dial number. The number is *99***1#.
Multi-Tech Systems, Inc. Quick Start Guide 13