Grandstream Networks GXP-280 User Manual page 29

IP address or Domain name of the STUN server. STUN resolution result will display in
STUN Server
the STATUS page of the Web UI.
Default method is HTTP. Firmware upgrade may take up to 10 minutes depending on
Firmware
network environment. Do not interrupt the firmware upgrading process.
Upgrade and
Provisioning
Via TFTP Server This is the IP address of the configured TFTP server. If selected and it is non-zero or not
blank, the GXP will attempt to retrieve a new configuration file or new code image from
the specified TFTP server at boot time. It will make up to 3 attempts before timeout and
then it will start the boot process using the existing code image in the Flash memory. If a
TFTP server is configured and a new code image is retrieved, the new downloaded
image will be verified and then saved into the Flash memory.
Note: Grandstream strongly recommends that the user upgrade firmware locally in a
LAN environment if using TFTP to upgrade. Please do NOT interrupt the TFTP upgrade
process (especially the power supply) as this will damage the device.
The HTTP server URL used for firmware upgrade and configuration via HTTP. For
Via HTTP
example:
Server
Here ":6688" is the specific TCP port that the HTTP server is using; omit if using default
port 80.
Note: If Auto Upgrade is set to No, GXP will only perform HTTP download once at boot
up.
IP address or domain name of firmware server.
Config Server
Path
Default is blank. If configured, GXP will request the firmware file with the prefix/postfix.
Firmware File
This setting is useful for ITSPs. End user should keep it blank.
Prefix/Postfix
Default is blank. End user should keep it blank.
Config File
Prefix/Postfix
Default is Yes. This allows device gets provisioned automatically.
Allow DHCP
Option 66 to
override server
Default is "No". If set to "Yes", configuration file would be authenticated before
Authenticate
acceptance. End user should use default setting.
Conf File
This function is used by ITSP. End user should NOT touch these parameters.
Automatic
Upgrade
Default is No. Choose "Yes" to enable automatic HTTP upgrade and provisioning.
In "Check for upgrade every" field, enter the number of minutes to check the HTTP
server for firmware upgrade or configuration changes. When set to "No", the phone will
only perform HTTP upgrade and configuration check once at boot up.
IP address or domain name of LDAP script server
LDAP Directory
Enable the XML phonebook via TFTP or HTTP. Define XML server path and download
Phonebook
interval. When the user downloads the XML phone the manually entered or edited
XML
entries will not be deleted unless this option is selected to Yes.
Grandstream Networks, Inc.
http://provisioning.mycompany.com:6688/Grandstream/1.1.6.44.
GXP User Manual
Firmware 1.1.6.46
Page 29 of 39
Last Updated: 03/2008