Avocent CYCLADES ACS 6000 Installation & Administrators Manual page 51

d. For Avocent/Cyclades PDUs, enter the power cycle interval and then use the drop-
down menus to enable or disable Syslog, Buzzer and SW Overcurrent Protection.
5. Click Save.
Table 3.7: Power Parameters
Parameter
Physical
Enable Cisco RJ-45
Pin-Out
Status
Speed
Parity
Data Bits
Stop Bits
Flow Control
Power
PDU Type
Enable Speed Auto
Detection
Pooling Rate
For Avo-
cent/Cyclades PDUs
Chapter 3: Accessing the Console Server via the Web Manager
Description
Defines the serial port pinout. Default: Disabled.
Defines the status of the serial port as either enabled or disabled.
Default: Disabled.
Defines the speed as 300, 1200, 2400, 4800, 9600, 19200, 38400,
57600 or 115200. Default: 9600.
Defines the parity as either Even, Odd or None. Default: None.
Defines the data bits as either 5, 6, 7 or 8. Default: 8.
Defines the stop bits as either 1 or 2. Default: 1.
Defines the flow control as none, hardware, software, RxON software
or TxON sofware. Default: None.
Defines the type or vendor of the PDU connected to the serial port.
• Auto - the vendor will be detected.
• Avocent-Cyclades - Avocent-Cyclades PM PDU family.
• SPC - SPC power control device family.
• Server Tech - Server Tech family.
Default: Auto.
When enabled, detects the speed of the port. Default: Disabled.
The interval in seconds to update information from the PDU. Default:
20.
43