Avocent CYCLADES ACS 6000 Installation & Administrators Manual page 48

40 Cyclades™ ACS 6000 Advanced Console Server Installation/Administration/User Guide
Parameter
Enable Auto Answer
DTR Mode
DTR Off Interval
Line Feed Suppression
Null After CR Sup-
pression
Transmission Interval
Break Sequence
Break Interval
Log In/Out Multi Ses-
sion Notification
Informational Message
Notification
Data Buffering
Status
Type
Time Stamp
Description
When the input data matches one input string configured in Auto
Answer, the output string will be transmitted to the serial port. Default:
Disabled.
DTR Mode can be set to the following: Always On. Normal - the DTR
status will depend on the existence of a CAS session. Off Interval -
when the a CAS session is closed, the DTR will stay down during this
interval. Default: Normal.
Interval in seconds used by DTR Mode Off Interval in milliseconds.
Default: 100.
Enables the suppression of the LF character after the CR character.
Default: Disabled.
Enables the suppression of the NULL character after the CR char-
acter. Default: Disabled.
The interval the port waits to send data to a remote client in mil-
liseconds. Default: 20.
Sequence used to send a break signal to the serial port. Not available
for Raw. Default: ~break.
Interval for the break signal in milliseconds. Not available for Raw.
Default: 500.
Enables the notification to multi-session users when a new user logs in
or a user logs out. Not available for Raw. Default: Disabled.
Displays an information message when a target session is opened. Not
available for Raw. Default: Enabled.
Enables or disables data buffering. Default: Disabled.
Displays the type of data buffering: Local - stores the data buffering file
in the local file system. NFS - stores the data buffering file in the NFS
server. Syslog - sends the data to the syslog server. DSView - sends
the data to the DSView 3 software. Default: Local.
When enabled, adds the time stamp to the data buffering line for a
Local or NFS database. Default: Disabled.