Avocent CYCLADES ACS 6000 Installation & Administrators Manual page 49

Parameter
Log-in/out Message
Serial Session Logging
Alerts
Status
Alert Strings
To configure the Dial-in Profile for a serial port with a connected modem:
1. Select Ports - Serial Ports.
2. Click the checkbox for a serial port with a connected modem.
3. Click the Set Dial button and use the drop-down menus to configure the dial-in settings.
4. Configure the PPP parameters (address, authentication and so on) and click Save.
Table 3.6: Dial-in Parameters
Parameter
Status
Speed
Init Chat
PPP Address
Local IPv4/IPv6
Address
Remote IPv4/IPv6
Address
Chapter 3: Accessing the Console Server via the Web Manager
Description
Includes special notification for logins and logouts in data buffering.
Default: Disabled.
Enabled - stores data at all times. Disabled - stores data when a CAS
session is not opened. Default: Enabled.
A special event notification will be generated when input data matches
one of the alert strings. Default: Disabled.
Strings used to generate event notifications. Default: Empty.
Description
Enables or disables the port. Default: Disabled.
The speed that will be used by mgetty to configure the serial device.
Default: 38400 bps.
Chat for modem initialization. Default: "" \d\d\d+++\d\d\dATZ OK.
Configures the local and the remote IP address for the the PPP link. If
Accept Configuration from Remote Peer is selected, the remote peer
should send both IP addresses (local and remote) during negotiation.
Default: No Address.
Configures the local IPv4/IPv6 address for this PPP connection.
Configures the remote IPv4/IPv6 address for this PPP connection.
41