Speed Governor Wiring Diagram; Kd 625-2 Workshop Manual_Cod. Ed0053029380_1° Ed_ Rev - Kohler KD 625/2 Workshop Manual

Air-cooled, direct injection

Hide thumbs Also See for KD 625/2:

Use & maintenance (160 pages)

Owner's manual (136 pages)

Specifications (4 pages)

Table Of Contents

Table of Contents

Disassembly / Reassembly

100

Magnetic sensor

24V electric control unit

101

- 50 -

Adjustment of the stroke end (STOP):

1 - Remove the conical plug "5".

2 - Through the eccentric "7" position and check by sight that the le-

ver in stop position is at the extreme left.

3 - From this position, always acting on the eccentric screw "7",

move the control lever 1,0 ÷ 1,5 mm to right.

4 - Lock the lock nut of the screw "7".

5 - Reassamble the conical plug "5".

Adjustment of extra fuel delivery:

1 - Remove the conical plug "4".

2 - Power the electromagnet "2" with a 12V voltage and make sure

that the plunger has moved. In this case you will hear the typical

activated magnet sound.

3 - Feed actuator "6" with a tension of 12V (put between the actuator

and the 12V a 10 Amp. fuse): the actuator tension will cause the

pump delivery control lever to move to the right.

4 - By the eccentric screw "3" place and check by sight that the lever

in Max position is at the extreme right; from this position, always

acting on the screw "3", move the delivery control lever by 1,0 ÷

1,5 mm to the left .

5 - Lock the lock nut of screw "3".

6 - Remove feeding from actuator "6" e electromagnet "2".

7 - Reassamble the conical plug "4".