Crankshaft; Center Main Bearing Support, Locating Screw; Crankshaft Removal; Crankshaft Center Main Bearing Support - Kohler KD 625/2 Workshop Manual

4
Disassembly / Reassembly
68
69
70
71
- 42 -
72

CRANKSHAFT

Center main bearing support, locating screw.

Straighten plate 1 and unscrew screw 2 before removing crankshaft.
 When assembling tighten the screw at a torque of 30 Nm.

Crankshaft removal

To pull out the crankshaft tap lightfy on the timing side end using a
copper-headed hammer.
When refitting align center main bearing support so that the locating
screw hole coincides with the crankcase hole.

Crankshaft center main bearing support

When refitting, both centering notches A and B must be located on the
same side.
Tighten screws at 25 Nm.


See page 44 ÷ 45 for dimensions.

Crankshaft lubrication ducts

Danger - Attention
During repair operations, when using compressed air, wear eye
protection.
Remove plugs, clean duct A with a pointed tool and blow in compressed
air. Screw plugs again and check for sealing.
KD 625-2 Workshop Manual_cod. ED0053029380_1° ed_ rev. 00