Remote Control - Regency THE INDOOR/OUTDOOR FAN Owner's Manual

R C
EMOTE ONTROL
G G I I
E E N N E E R R A A L L N N F F O O R R M M A A T T I I O O N N
Multiple code choices are included with your fan' s remote control in case:
• you have more than one remote control fan and want them to respond only to their own remote control
• you have other radio controlled devices in your home that may interfere with the fan remote control (i.e. garage
door opener)
• you experience radio interference on a chosen frequency (code setting)
S S - - O O
E E T T U U P P A A N N D D P P E E R R A A T T I I N N G G
S S e e t t t t i i n n g g t t h h e e c c o o d d e e : :
This unit has 16 different code combinations. To set the code, perform these steps:
1. Setting the code on the TRANSMITTER [Fig. 1]:
a. Remove battery cover.
b. Slide code switches to your choice of ON or OFF position. Use a small screwdriver or ball point pen to slide
each switch firmly up or down.
c. Install 9v battery (not included).
d. Replace battery cover on transmitter.
2. Setting the code on the RECEIVER [Fig. 2]:
a. Locate the code switches on the bottom of the remote receiver.
b. Slide code switches to the SAME POSITIONS as set on your transmitter.
TRANSMITTER
O N EC E
1 2 3 4
After codes are set, install the receiver
in the space above the ball in the
hanger bracket [Fig. 3]. Be careful not
to pinch any of the receiver' s wires.
I I
N N S S T T R R U U C C T T I I O O N N S S
Code
Switches
Fig. 1
Antenna
Hanger
bracket
Ball
7
RECEIVER
P D I N O
Code
Switches
Fig. 2
Receiver
Fig. 3