Remote Control - Regency Bimini Owner's Manual

R C
EMOTE ONTROL
G I
ENERAL NFORMATION
Multiple code choices are included with your fan' s remote control in case:
• you have more than one remote control fan and want them to respond only to their own remote control
• you have other radio controlled devices in your home that may interfere with the fan remote control (i.e. garage
door opener)
• you experience radio interference on a chosen frequency (code setting)
NOTE: Factory code settings should not be used.
S - O
ET UP AND PERATING
Setting the code:
This unit has 16 different code combinations. To set the code, perform these steps:
1. Setting the code on the TRANSMITTER [Fig. 1]:
a. Remove battery cover.
b. Slide code switches to your choice of ON or OFF position. Use a small screwdriver or ball point pen to slide
each switch firmly up or down.
c. Install 9v battery (not included).
d. Replace battery cover on transmitter.
2. Setting the code on the RECEIVER [Fig. 2]:
a. Locate the code switches on the top of the remote receiver under rubber seal cover.
b. Slide code switches to the SAME POSITIONS as set on your transmitter.
c. Reinstall seal cover.
TRANSMITTER
ON EC E
1 2 3 4
Fig. 1
After codes are set:
1. Install the receiver in the space above the ball
in the hanger bracket [Fig. 3]. Be careful not
to pinch any of the receiver' s wires.
2. Slide canopy up and secure with set screws
in hanger bracket.
I
NSTRUCTIONS
Code
Switches
Antenna
Fig. 2
Fig. 3
8
RECEIVER
Code
Switches
Hanger
bracket
Ball
Receiver