Electrical Connections; Blade Attachment - Regency THE INDOOR/OUTDOOR FAN Owner's Manual

E C
LECTRICAL
*
Be sure electricity is turned off at the main power box before wiring.*
Four wires are connected to the fan (plus the ground wire).
Black - the "hot" power to run fan.
White - the "common" power to run fan and light,
also referred to as "AC neutral".
Blue - the "hot" power for lower light.
Gray - the "hot" power for upper light.
Green - ground wire.
Six wires are connected to the remote control receiver. Four
will connect to the four wires coming out of the fan
(matching color to color) and the remaining black wire and
white wire will connect to the building 110v AC circuit.
BE SURE ELECTRICITY IS TURNED OFF AT THE
MAIN POWER BOX BEFORE WIRING.
Connect six power wires as shown [Fig. 1], using wire nuts
provided. Connect green ground wires to building ground
wire circuit. Extend antenna wire inside canopy, but do not
attach to any other wire.
NOTE: If power to the fan' s electrical ceiling box is controlled by a wall switch, the wall switch must remain ON
for the radio remote control to operate. Turning the wall switch OFF will turn off all fan/light function and resets
the receiver back to default mode. The wall switch will need to be turned back ON to allow use of remote control.
* Restore power by replacing fuse or resetting circuit breaker ONLY AFTER ALL INSTALLATION AND ELECTRICAL
WORK IS COMPLETED AND DOUBLE-CHECKED.
B A
LADE TTACHMENT
1. Place washer on screw. Insert this assembly through the
blade and start the screw into the blade arm. Repeat this
procedure without tightening the screw until all 3 screws
have been started into the blade arm (Fig. 2).
2. Tighten each screw, starting with center screw.
ONNECTIONS
Screw
8
Receiver
Antenna
Washer
Blade
Blade Arm
Fig. 1
Fig. 2