Advertisement

Quick Links

Style that revolves around you.
• C
F
O
M
EILING
AN
WNER'S
ANUAL
• Q
UATRO
10/09
WARNING: Read and follow these instructions carefully and be mindful of all warnings shown throughout.

Advertisement

Table of Contents
loading

Summary of Contents for Regency Quatro

  • Page 1 Style that revolves around you. • C • EILING WNER'S ANUAL • Q • UATRO 10/09 WARNING: Read and follow these instructions carefully and be mindful of all warnings shown throughout.
  • Page 2 & O ENERAL NSTALLATION PERATION NSTRUCTIONS MPORTANT AFEGUARDS: 1. To ensure the success of the installation, be sure to read the instructions and review the diagrams thoroughly To ensure the success of the installation, be sure to read the instructions and review the diagrams thoroughly before beginning.
  • Page 3: Important Safety Precautions

    MPORTANT AFETY RECAUTIONS Thank you for choosing a Regency Ceiling Fan. You have chosen the best! Your new ceiling fan has been designed to provide many years of service and enjoyment. Warnings: Warnings: • Disconnect power by removing fuse or turning off circuit breaker before installing the fan.
  • Page 4: Unpacking Your Fan

    NPACKING 1. Unpack your fan and check the contents. Do not discard the carton. If warranty replacement or repair is ever necessary, the fan should be returned in original packing. Remove all parts and hardware. Do not lay motor housing on its side, or the decorative housing may shift, be bent or damaged. 2.
  • Page 5: Hanging Bracket

    REPARATION Parts identification on assembled fan Canopy Motor Housing Downrod Collar Cover Blades Light Plate Globe PREPARATION: Verify you have all parts before beginning the installation. Check foam insert closely for missing parts. Remove motor from packing. To avoid damage to finish, assemble motor on soft padded surface or use the original foam inset in motor box.
  • Page 6 NSTALLING THE 1. Carefully support fan body (motor) in its styrofoam packing with the mounting collar (where the wires come Hook-up (3) out) facing upward. Wires Ground 2. Loosen the two set screws and remove the downrod pin Wire and cotter pin from the top coupling of the motor assembly.
  • Page 7 LECTRICAL ONNECTIONS WARNING: WARNING: To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring. Multiple code choices are included with your fan¡¦s remote control in case: * you have more than one remote control fan and want them to respond only to their own remote control. * you have other radio controlled devices in your home that may interfere with the fan remote control.
  • Page 8 LECTRICAL ONNECTIONS Step 3. (Fig. 3) Receiver to House Supply Wires Electrical Connections: Connect the black (hot) wire from the Outlet box ceiling to the black wire marked "AC in L" from the receiver. Connect the white(neutral) wire from the ceiling White (neutral) Black (hot) to the white wire marked "AC in N"...
  • Page 9: Finishing The Installation

    INISHING THE NSTALLATION 1. Tuck connections neatly into ceiling outlet box. Ceiling Fan 2. Slide the canopy up to ceiling and over the 2 screws on Outlet Box the hanger bracket. Rotate canopy clockwise. Next, while Hanger Bracket holding the canopy with one hand, slide the canopy screw cover plate over the screws and rotate clockwise Screws until tight.
  • Page 10 NSTALLATION THE ONTING LATE NSTALLING THE IGHT LATE 1. Remove one of the three screws on the mounting hub located on the fan motor. 2. Loosen the other two screws. 3. Install light plate to mounting hub. 4. Line up the two slotted holes with the two loose screws on the mounting hub located on fan motor. 5.
  • Page 11 NSTALLING THE IGHT ULB AND LOBE NOTE: Be sure the power is off before installing. NOTE: Be sure the power is off before installing. NOTE: NOTE: IF YOU DO NOT PLAN TO INSTALL THE LIGHT KIT WITH YOUR FAN AT THIS TIME, THEN GO STRAIGHT TO STEP 2.
  • Page 12: Operating Your Wall Transmitter

    PERATING RANSMITTER Restore power to ceiling fan and test for proper operation. Install 9 Volt battery (not included). To prevent damage to transmitter remove the batteries if not used for long periods of time. (Fig. 1) 1. "LO, MED, HI" buttons: These three buttons are used to set the fan speed as follows: LO= Low speed MED= Medium speed HI= High speed...
  • Page 13 Speed settings for warm or cool weather depend on factors such as the room size, ceiling height, number of fans, etc. NOTE: NOTE: To operate the reverse function on this fan, press the "FOR/REV" button while the fan is running. Warm weather-(Counter-Clockwise direction) A downward air flow creates a cooling effect.(Fig.
  • Page 14: Troubleshooting

    Make sure these are tight and the ball is completely seated in the bracket. HANK YOU FOR PURCHASING A EGENCY EILING Write to us at: Regency Ceiling Fans P.O. Box 730 Fenton, MO 63026 Visit us on the Web at: www.regencyfans.com 10/09 Regency Ceiling Fans...

Table of Contents