Related Manuals for Regency THE INDOOR/OUTDOOR FAN
Summary of Contents for Regency THE INDOOR/OUTDOOR FAN
- Page 1 ’ • • EILING WNER ANUAL 5/03 • I/O • “T ” NDOOR UTDOOR WARNING: Read and follow these instructions carefully and be mindful of all warnings shown throughout.
- Page 3 & O ENERAL NSTALLATION PERATION NSTRUCTIONS M M P P O O R R T T A A N N T T A A F F E E G G U U A A R R D D S S 1.
-
Page 4: Safety Precautions
MPORTANT AFETY RECAUTIONS Thank you for choosing a Regency Ceiling Fan. You have chosen the best! Your new ceiling fan has been designed to provide many years of service and enjoyment. A A R R N N I I N N G G S S D D i i s s c c o o n n n n e e c c t t p p o o w w e e r r b b y y r r e e m m o o v v i i n n g g f f u u s s e e o o r r t t u u r r n n i i n n g g o o f f f f c c i i r r c c u u i i t t b b r r e e a a k k e e r r b b e e f f o o r r e e i i n n s s t t a a l l l l i i n n g g t t h h e e f f a a n n a a n n d d / / o o r r o o p p t t i i o o n n a a l l l l i i g g h h t t i i n n g g . - Page 5 NPACKING 1. Unpack your fan and check the contents. Do not discard the carton. If warranty replacement or repair is ever necessary, the fan should be returned in original packing. Remove all parts and hardware. Do not lay motor housing on its side, or the decorative housing may shift, be bent or damaged.
-
Page 6: Mounting Bracket
REPARATION Parts identification on assembled fan Canopy Fan Housing Downrod Blade Blade Arm Glass Shade R R E E P P A A R R A A T T I I O O N N Verify that you have all parts before beginning the installation. Check foam insert closely for missing parts. Remove motor from packing. - Page 7 SSEMBLY NSTRUCTIONS OWNROD AND CANOPY 1. Carefully support fan housing (motor) in its styrofoam packing with the mounting collar (where the wires come out) facing upward. 2. Remove ball from downrod by loosening set screw in the side of the ball. Slide ball down and remove ball pin; remove ball.
- Page 8 NSTALLING 1. Lift ball/downrod/fan into hanger bracket opening. NOTE: The tab opposite hanger bracket opening should fit in slot on ball. 2. Install remote control receiver (with codes set) and make wire connections, (refer to sections titled “Remote Control” and “Electrical Connections”). 3.
-
Page 9: Remote Control
EMOTE ONTROL E E N N E E R R A A L L N N F F O O R R M M A A T T I I O O N N Multiple code choices are included with your fan’ s remote control in case: •... -
Page 10: Electrical Connections
LECTRICAL ONNECTIONS Be sure electricity is turned off at the main power box before wiring.* Four wires are connected to the fan (plus the ground wire). Black - the “hot” power to run fan. White - the “common” power to run fan and light, also referred to as “AC neutral”. -
Page 11: Installation
OMPLETING THE NSTALLATION 1. Install “J” type halogen bulb into lower socket on bottom of fan. Do not touch bulb with bare fingers. Use tissue of bulb’ s packing to keep fingerprints and oils off bulb’ s surface. 2. Lift bottom glass shade up to fan, aligning indentations in glass with nubs on bottom of fan [Fig. 2]. Turn glass shade to secure in place. -
Page 12: Operation
PERATION P P E E R R A A T T I I N N G G B B U U T T T T O O N N S S O O N N T T H H E E R R A A N N S S M M I I T T T T E E R R H H I I –... -
Page 13: Care And Cleaning
ARE AND LEANING Periodic cleaning of your new ceiling fan is about the only maintenance that is needed. Only use a soft brush or lint free cloth to avoid scratching the finish. DO NOT use water when cleaning your ceiling fan. It could damage the motor or the blades and/or create the possibility of electrical shock. - Page 16 HANK YOU FOR PURCHASING A EGENCY EILING Write to us at: Regency Ceiling Fans P.O. Box 730 Fenton, MO 63026 Visit us on the Web at: www.regencyfan.com 5/03 Regency Ceiling Fans...