Chapter 3 Getting Started; Setting Up The Printer - Brady LabXpert User Manual

Chapter 3
Getting Started
This chapter provides instructions on setting up your LABXPERT
Refer to the following chapter for details on how to use the keypad and menu.

Setting up the printer

Follow these steps to set up your printer prior to creating your first label.
Step 1. Install batteries or connect to power.
To insert six AA alkaline batteries (not included),
1. Remove the battery cover located on the backside of the printer.
2. Install the batteries as shown. See inside the battery compartment for the battery-positioning grid.
3. Close the battery compartment.
Note: You can print up to 650 labels between battery changes.
The LABXPERT printer can also be powered by use of the A/C adaptor provided with your
TM
printer. See the Connections section on page 5.
Step 2. Replace material cartridge.
Note: Make sure to cut off any excess label material before removing an existing
cartridge.
Your printer ships with a cartridge installed. Follow the instructions on the next page to replace the
existing cartridge.
User Manual
printer and creating a basic label.
TM
Battery
Cover
7