Triggercontrol - Toshiba teli BG030 Instruction Manual

TriggerControl

This section describes trigger control of AcquisitionControl category for the BG series.
This camera series provides two kinds of exposure synchronization.
1. Normal Shutter mode
2. Random Trigger Shutter mode
In Random Trigger Shutter mode, two kinds of trigger input are available.
1. Trigger signal via the I/O connector (HardwareTrigger)
2. Trigger command via the Gigabit Ethernet interface (SoftwareTrigger)
The following table shows the combination of operation mode of this camera series.
Trigger Mode
Normal Shutter mode
Random Trigger Shutter mode
Operation point of HardwareTrigger is at the edge of trigger signal, and active edge polarity is able to change
by register setting. And you can add delay time from trigger edge to exposure start by register setting.
Copyright © 2012 - 2013 TOSHIBA TELI CORPORATION, All rights reserved.
: Free run operation (internal synchronization)
: Synchronized with external trigger input
Table. Operation Mode
Synchronization
Free run
HardwareTrigger
SoftwareTrigger
* The camera operation not mentioned above is not guaranteed.
Fig. Trigger Delay
48 / 85
Exposure Control
"ExposureTime" register control
ALC control
"ExposureTime" register control
Trigger pulse width control
"ExposureTime" register control
http://www.toshiba-teli.co.jp/index.htm
D4211908E