Toshiba teli BG030 Instruction Manual page 41

● Setting
- Set image size and image start position
Set the following value to "Width", "Height", "OffsetX", "OffsetY" registers. Setting value is Integer type.
"Width", "Height" registers are image size setting. "OffsetX", "OffsetY" registers are image start position
setting.
Model
Width unit size
Height unit size
OffsetX unit size
OffsetY unit size
Minimum unit size
Maximum unit size (*)
● Note
Changing "Width", "Height", "OffsetX", "OffsetY" register value is invalid during image stream data output.
Notes on scalable mode:
White lines may occur in the upper portions of the screen when strong light exists in a wide area during the scalable
mode. This is not a malfunction. If white lines occur, adjust the amount of incident light using the lens.
Copyright © 2012 - 2013 TOSHIBA TELI CORPORATION, All rights reserved.
BG030 /
BG031
BG030C
160 160
60 60
32 32
12 12
160×60 160×60
640×480 640×480
40 / 85
BG130 /
BG080
BG130C
256 160
96 60
32 32
12 12
256×96 160×60
1024×768 1280×960
http://www.toshiba-teli.co.jp/index.htm
BG202
160
60
32
12
160x60
1600x1200
* initial factory setting
D4211908E