Connection - Toshiba teli BG030 Instruction Manual

Connection

● In the case of supply DC+12V to the camera.
● In the case of supply PoE power to the camera.
Notes on Connection:
- Please confirm the power supply of the camera off when plugging in or pulling out the I/O Connector. It causes the
breakdown.
- If your camera is used in a system where its connectors are subjected to strong repetitive shocks, its connectors are
possible to break down. If you use your camera in such a situation, use an LAN cable with a lock screw, and secure
the camera cable as close as possible to the camera body for avoid physical shock to the camera connector.
- About Camera cable: In the case that electric-wire is long or thin, input voltage may not satisfy specifications of the
power supply voltage of the camera by voltage drop. Please confirm it before use.
-
Lost packets may occur by an electrical characteristic of the transmission line of using Ethernet devices (LAN cable,
Network Interface Card, Switching HUB).
Copyright © 2012 - 2013 TOSHIBA TELI CORPORATION, All rights reserved.
15 / 85
D4211908E
http://www.toshiba-teli.co.jp/index.htm