Toshiba teli BG030 Instruction Manual page 51

- Selects trigger source
Set the following value to "TriggerSource" register. Setting value is Enumeration type.
- Grabs image stream by software trigger
When executes "TriggerSoftware" register command, software trigger command is generated. And the
camera starts exposure by receiving software trigger command in software trigger mode
- Changes trigger polarity (HardwareTrigger operation only)
Set the following value to "TriggerActivation" register. Setting value is Enumeration type.
- Sets trigger delay (HardwareTrigger operation only)
Set the following value to "TriggerDelay" register. Setting value is Float type.
Adds delay time from trigger edge to exposure start.
- Sets sampling period for Anti-Chattering (HardwareTrigger operation only)
Set the following value to "TriggerSamplingPeriod" register. Setting value is Float type.
Copyright © 2012 - 2013 TOSHIBA TELI CORPORATION, All rights reserved.
setting value
Line0 (*)
Software
setting value
FallingEdge (*)
RisingEdge
setting value
Minimum (*)
Maximum
setting value TriggerSamplingPeriod[µs]
Minimum (*)
Maximum
50 / 85
Trigger source
Hardware trigger
Software trigger
* initial factory setting
Polarity
Negative
Positive
* initial factory setting
TriggerDelay
0.00[µs]
4095.00[µs]
* initial factory setting
2.00[µs]
1000.00[µs]
* initial factory setting
http://www.toshiba-teli.co.jp/index.htm
D4211908E