Toshiba teli BG030 Instruction Manual page 80

● Registers
Register
UserSetSelector
UserSetLoad
UserSetSave
UserSetDefaultSelector
● Setting
- Select a bank of the user setting
Set the following value to "UserSetSelector" register. The setting value is Enumeration type.
Select the bank of user setting for "UserSetLoad" and "UserSetSave".
setting value
Default (*)
UserSet1
UserSet2
UserSet3
"Default" bank is only used for loading data. If you want to restore a camera setting to the initial factory
setting, please load "Default" bank.
- Load/Save a user setting
When execute "UserSetLoad", the camera loads the user setting of bank that is selected in
"UserSetSelector" register and applies them.
When execute "UserSetSave", the camera saves a user setting that was applied to the bank that is
selected in "UserSetSelector" register.
- Load the user setting at the time of start-up
Set the following value to "UserSetDefaultSelector" register. The setting value is Enumeration type.
When select "UserSetDefaultSelector" register and save it, the camera loads the user setting of bank that
is selected in "UserSetDefaultSelector" register and applies them at the time of next start-up.
● Note
Changing "UserSetLoad" register value is invalid during image stream data output.
Copyright © 2012 - 2013 TOSHIBA TELI CORPORATION, All rights reserved.
Visibility Access
Beginner R/W Selects a bank of user setting.
Beginner W Executes load of the user setting.
Beginner W Executes to save the user setting.
Beginner R/W Selects a bank of user setting when camera powers up.
Memory bank to read initial factory setting data.
Memory bank 1 for user setting.
Memory bank 2 for user setting.
Memory bank 3 for user setting.
Description
79 / 85
Description
Save Load
○
×
○ ○
○ ○
○ ○
* initial factory setting
http://www.toshiba-teli.co.jp/index.htm
D4211908E