Toshiba teli BG030 Instruction Manual page 56

● Setting
- Select the Line of the I/O connector
Set the following value to "LineSelector" register. The setting value is Enumeration type.
LineSelector
Line0 (*)
Line1
Line2
- Select the polarity of GPIO output signal
Set the following value to "LineInverter" register. The setting value is Boolean type.
- Select the source of GPIO output signal
Set the following value to "LineSource" register. Setting value is Enumeration type.
LineSource
Off (*)
FrameTriggerWait
FrameTransfer
FrameActive
ExposureActive
Timer0Active
VD
● Note
About the details of Timer0Active signal, refer to "TimerControl" of "Functions".
Copyright © 2012 - 2013 TOSHIBA TELI CORPORATION, All rights reserved.
I/O connector pin assignment
2 pin: External Trigger Input
3 pin: GPIO0 Output
4 pin: GPIO1 Output
LineInverter
FALSE (*)
TRUE
No output.
Indicating waiting a Random Trigger Shutter.
An External trigger is input during this period, exposure starts immediately.
Period of transferring image data on Ethernet bus.
Period from exposure start to CCD transfer completion.
Period from exposure start to exposure end.
This signal can be used as strobe control signal.
The delay time and pulse width of this signal are configurable.
Internal VD sync signal.
LineMode
Input OptoCoupled: OpenCollector
Output TTL: LVTTL
Output OptoCoupled: OpenCollector
Polarity
ActiveLow
ActiveHigh
* initial factory setting
Signal description
55 / 85
LineFormat
* initial factory setting
* initial factory setting
D4211908E
http://www.toshiba-teli.co.jp/index.htm