Gauge Setup - Bully Dog GT Owner's Manual

GAUGE sETUp

Enter to change the vehicle parameters (PIDs) displayed on the four gauge locations
in the Main Screen. To see a list of all vehicle parameters available see the following
page for parameters and descriptions.
Selecting a vehicle parameter to display in a particular location is done by highlighting the
gauge location and then highlighting the desired vehicle parameter.
Once the correct vehicle parameter for a gauge location has been highlighted, you do not
need to press another button to select that vehicle parameter. Simply highlighting the
vehicle parameter makes it active in that location.
Notice that upon entering the gauge setup menu that, Set Gauge 1, is highlighted in black. When a gauge
location is selected it is highlighted in black on the left and it also appears above the vehicle parameter
selection box.
To highlight a different gauge location press the
selection button that coincides with that gauge
location. So to select gauge location 1, press the
second button down on the left hand side of the
GT. To select the 4th gauge location press the
bottom button or the 5th button down on the
left side.
Go back
GAUGE sETUp
speed
Gauge 1
Set Gauge 1
Use the Up & Down Arrows to
Change the Tranny Tune
boost
Set Gauge 2
Pyro 2
Speed
Rpm
Boost
Set Gauge 3
Coolant
Set Gauge 4
®
Use the large Up Down Buttons to highlight a
particular vehicle parameter for any of the gauge
locations.
OperATION
47