Step 3: Running Gt Main Wire Harness - Bully Dog GT Owner's Manual

step 3:
run gt Main wire harness
In this section you will connect the GT Main Harness to the OBD ll Adaptor plug and then run the
other end of the main harness up the side of the vehicle dash and connect it to the back of the GT.
1. Plug one end of the Main Harness into the Main Harness port on the OBD ll adapter plug.
2. Run the other end of the harness up through the vehicle dash on the driver' s side so that the end of the
harness emerges from the dash near the vehicle A-pillar. It may be necessary to temporarily remove
the vehicle weather stripping and dash panel to achieve an installation where the Main Harness can-
not be seen.
3. Plug the Main Harness into the back side of the GT, make sure that there is enough slack in the main
harness to accommodate mounting the GT to the windshield.
INSTALLATION
19