Table of Contents
Advertisement
Utility Tool
Setup for Bindery Emulation
Make sure of the Bindery Context.
Before connecting the print server (network interface card) to the Novell NetWare 4.x-6 server of Bindery
mode, make sure that the NetWare server contains the bindery context.
If the bindery context does not exist, the network administrator should modify the AUTOEXEC.NCF file to add
an adequate SET command and restart the NetWare server or enter a SET command from the console
prompt to make changes.
Note that any command entered following the console prompt is effective immediately but the definition of
the autoexec.ncf file becomes effective only after turning off power and on again.
Setup with PCONSOLE in Bindery mode.
If you are sure that the bindery context exists in the file server, you can set up the print server with
PCONSOLE.
!
Detail
Refer to the Novell NetWare manual for details of setup with PCONSOLE.
In Bindery mode, only upper-case letters are valid for the printer server password.
VarioLink 9522 (Version 2)
12
12-23
Advertisement
Table of Contents
Troubleshooting
