Sliding Handle Assembly (Premier 170); Hose Hanger, Regulator Storage Bracket & Thermostat Storage Bracket - L.B. White TS080 Owner's Manual And Instructions

The Premier 170 is equipped with sliding handles for
convenient "wheel-barrow" style mobility.
-- Depress the snap-button on the underside of the
sliding handle storage bracket.
-- Fully extend both handles until the snap button locks
into place.
-- For storage, depress the snap button and push the
handles to fully retracted position.
1. Hose Hanger Assembly
a. Align wire hose hanger to cage nuts on back of
heater.
b. Mount the hanger using the 1/4-20 x 3/4 in.
bolts and 1/4 in. flat washers. Tighten securely.
See Fig. 2.
2. Thermostat Storage Bracket Assembly
a. Align regulator storage bracket to the four 1/8 in.
diameter holes on heater case back.
b. Mount the storage bracket to the case using the
four 3/8 in. hex head screws. Tighten securely.
See Fig. 2. Store the thermostat as shown in Fig.
3 when not in use.
3. Regulator Storage Bracket Assembly (PREMIER 170)
a. Align regulator storage bracket to the two 1/8 in.
diameter holes on heater case back.
b. Mount the storage bracket to the case using the
two 3/8 in. hex head screws at this point.
Tighten securely. See Fig. 2.
FIG. 1
HANDLE BRACKET
HOSE HANGER, REGULATOR STORAGE BRACKET
& THERMOSTAT STORAGE BRACKET
FIG. 2
CAGE NUTS
FIG. 3
Thermostat Storage
INTERNAL VIEW
SLIDING HANDLE ASSEMBLY
EXTEND HANDLE
UNTIL IT SNAPS INTO
RETAINING HOLE
RETAINING HOLE
AT UNDERSIDE
SNAP BUTTON
AT UNDERSIDE
HOSE HANGER
FLAT WASHER
BOLT
THERMOSTAT STORAGE
BRACKET
(INSTALLED WITH INTERNAL
SUPPORT TO THE LEFT)
REGULATOR STORAGE
BRACKET
THERMOSTAT CASE
RESTS ON SUPPORT
BRACKET
Premier 170
SCREWS
TS170G-02
9