Mounting The Zr2040W Panel - HP ZR2040w User Manual

NOTE:
This apparatus is intended to be supported by a UL or CSA Listed wall mount bracket.
CAUTION:
is designed to support a maximum of up to 10.9 kg (24 lbs). If you are mounting to a wall, HP
recommends that you consult with a qualified engineering, architectural, or construction professional to
determine the appropriate type and quantity of mounting fasteners required for your application and to
ensure that the mounting solution is properly installed to support applied loads.
The weight for your model can be found in
Before you begin, make sure the monitor is turned off and the power and signal cables are
disconnected. Also disconnect any USB cables. To protect the panel, lay it face down on a soft, flat
surface.

Mounting the ZR2040w Panel

1.
Remove the four screws holding the panel to the pedestal.
2.
To mount the panel, use the four holes surrounding the HP logo on the back of the monitor.
Figure 3-12
CAUTION:
attach a third-party mounting solution to the monitor, four 4 mm, 0.7 pitch, and 10 mm long
screws are required. Longer screws must not be used because they may damage the monitor. It is
important to verify that the manufacturer's mounting solution is compliant with the VESA standard
and is rated to support the weight of the monitor display panel. For best performance, it is
important to use the power and video cables provided with the monitor.
3. If you mount the panel in portrait orientation, you will need to rotate the image to match. See
Portrait Orientation on page 24
16 Chapter 3 Setting Up the Monitor
The HP Quick Release 2 can be installed directly to a wall to mount the monitor panel. It
Mounting the ZR2040w Model
This monitor supports the VESA industry standard 100 mm mounting holes. To
for instructions.
Technical Specifications on page 42.
ENWW